groenendael
Active Member
Use an inch and an one eighth preferably a ring spanner/socket.
classic kev
Well-Known Member
Big adjustable spanner works for me (assume sump plug) All the other bolts holding it on are 10mm.
Addyy is just rounding it off at the minute so will try a ring spanner on there.
redrenger89
New Member
Hi Goon,
29mm or inch and one eighth A/F from memory. And long handle wrench.
Have you lost your knuckles yet ? Most of the skin from mine is stuck to the sharp bits under the car.
Now you know why the garages bodge it by sucking the up through the dip stick. And this leaves all the gunge behind to damage your engine
Plugs are cheap around £2 so I would change it when you get it out.
Good Luck
Fred
29mm or inch and one eighth A/F from memory. And long handle wrench.
Have you lost your knuckles yet ? Most of the skin from mine is stuck to the sharp bits under the car.
Now you know why the garages bodge it by sucking the up through the dip stick. And this leaves all the gunge behind to damage your engine
Plugs are cheap around £2 so I would change it when you get it out.
Good Luck
Fred
classic kev
Well-Known Member
Try big Stillson wrench - that'll either sort it or b***er it completely.
BTW, would applying a bit of heat to the sump help then try undoing it?
BTW, would applying a bit of heat to the sump help then try undoing it?
rustyrangie
Active Member
stilsons, big spanner and hammers, :behindsofa: my god don't listen to these landy butcherin nasty people 
lol
get down halfords and buy a 29mm socket like i said and cut it down so it fits in the gap, clip on a decent size breaker bar and it'll come out no probs whatsoever, nothing broken/stripped and nuckles intact. if you can't afford one i'll post you my one as long as you promise to send it back
lolget down halfords and buy a 29mm socket like i said and cut it down so it fits in the gap, clip on a decent size breaker bar and it'll come out no probs whatsoever, nothing broken/stripped and nuckles intact. if you can't afford one i'll post you my one as long as you promise to send it back
redrenger89
New Member
Hi Goon,
If you use a ring spanner, place it in a downward position (Vertical) and slide under front of car, place your foot carefully on spanner and and push towards rear of car.
This sytem works for me, it wont work with a socket though as it falls off.
Good luck
Fred
If you use a ring spanner, place it in a downward position (Vertical) and slide under front of car, place your foot carefully on spanner and and push towards rear of car.
This sytem works for me, it wont work with a socket though as it falls off.
Good luck
Fred
when using any of the "high force" methods such as a jack - watch out for the sump distorting. I have known this happen, which is why I prefer an air impact driver, as it imparts a sudden shock loading onto the plug rather than a slow steady pressure.
redrenger89
New Member
Correct
But not easy when short of space
Could try
Place spanner in position and give it a kick
But not easy when short of space
Could try
Place spanner in position and give it a kick
Irishrover
Well-Known Member
Good pair of stillies, safer than a socket or ring spanner when the heads rounded and less likely to slip, forget the adjustable they only round the corners-even a good one like Bahco.
Buy the new plug & washer first.
Buy the new plug & washer first.
