jane-eliza
New Member
thanks beneagles
have a go at the spots yaself,or get someone to give you a hand,it aint that hard,just make sure you use a relay,i used 1 relay for each pair,so 4 spots =2 relays..wired into main beam but on a seperate switch so i can also switch the spots off and have normal main beam,welcome to the site..then when ive had that done, i want spots putting on the roof. any advice where to go![]()
you can take them in between the window seal then down door pillar ,but got to be carefull,some people drill hole in roof and seal it with rubber gromet,mine i got some flexi pipe sleeving,and ran it down back of the snorle and then took it through the gap i had in my bonnet...i wasnt botherd about it looking major good though,think their might be a section on here,just have a browse,hope this gives you a few ideas and helps...other people on here might be able to point you more in right direction,best regards,nunnyim only a mere female........but dont give up on me...........where do all the wires go, when the spots are on the roof??????
Could it be something you have with fish:hysterically_laughiwhat is dynachip