jamesmartin
Well-Known Member
blue hylomar for gaskets, dont glue front till preload is checked
aaronmorris
Head's a shed
Yes I have some hylomar blue in the shed so I'll use that.
Just been reading the manual with regards to setting the pre-load.
Earlier in the thread you said I want 0-2 thou pre-load. Is that for both the main shaft and lay shaft?
Manual says.
Main shaft, No pre-load and.not more than 0,06mm (0.0025in) end float.
Lay shaft, zero bearing end float and not more than 0,025" (0.001 in) pre-load.
Having pre-load makes sense to me, But the manuals made me all confused now
On another note is setting with feeler gauges as per manual the best way
Just been reading the manual with regards to setting the pre-load.
Earlier in the thread you said I want 0-2 thou pre-load. Is that for both the main shaft and lay shaft?
Manual says.
Main shaft, No pre-load and.not more than 0,06mm (0.0025in) end float.
Lay shaft, zero bearing end float and not more than 0,025" (0.001 in) pre-load.
Having pre-load makes sense to me, But the manuals made me all confused now
On another note is setting with feeler gauges as per manual the best way
jamesmartin
Well-Known Member
Yes I have some hylomar blue in the shed so I'll use that.
Just been reading the manual with regards to setting the pre-load.
Earlier in the thread you said I want 0-2 thou pre-load. Is that for both the main shaft and lay shaft?
Manual says.
Main shaft, No pre-load and.not more than 0,06mm (0.0025in) end float.
Lay shaft, zero bearing end float and not more than 0,025" (0.001 in) pre-load.
Having pre-load makes sense to me, But the manuals made me all confused now
On another note is it best to set it with feeler gauges as per manual.
both the same , once box is tight, before extension case is fitted you want no freeplay in either shaft,with just the feel that tightening front cover has added some preload
aaronmorris
Head's a shed
aaronmorris
Head's a shed
Put the front housing on to check preload, Put extension case on and pressed oil seal collar on.
[/URL][/IMG]
And it's done
Dead chuffed with how it's gone and thoroughly enjoyed it, Hmm do I fancy an R380 next
[/URL][/IMG]
But for now the next job is to put this diff back together and set it up properly.
Don't really understand what's needed for the pinion height, I've seen height blocks mentioned else where.
But I'll probably start another thread for that.
[/URL][/IMG]
And it's done
Dead chuffed with how it's gone and thoroughly enjoyed it, Hmm do I fancy an R380 next
But for now the next job is to put this diff back together and set it up properly.
Don't really understand what's needed for the pinion height, I've seen height blocks mentioned else where.
But I'll probably start another thread for that.
