A

ashleywood.ash

Active Member
Still having issues getting my engine in. Doesn't help that I only have an odd hour every few weeks.
Anyway Landy is in neutral but clutch pedal will not move. Is this normal with engine out?
 
has slave cylinder piston moved down against circlip if fitted thus making pedal stiff on looking at picture again it looks likeslave cylinder has pushed clutch release fork against gear box casing so you will need to push clutch release bearingback towords gear box
 
Last edited:
Still can't get the bloody engine in though.
I can get left side in as your facing it, but not the right.
Doing my head in no matter what I do.

In neutral
Disconnected prop
Wiggling crank
Greased input shaft
Double check clutch alignment
Using crane on engine and jack on gearbox
Wiggling with he-man like might

It just doesn't want to know
 
Last edited:
Are you on your own? This is one of those that an extra pair of eyes and hands makes a difference.
 
Oh my dear lord! I need a shot gun to the back of the head.

As it's different engine I'm putting in, it has a very slightly different bell housing. Said bell housing had one extra stud on the bottom right that my gearbox didn't have a hole for.
Removed stud and slotted it straight it!!!! :
Wasted about 4 hours :)
 
Weve all done it:D

I remember gassing to a mate whilst removing truck wheel nuts and for the life of me could not get the wheel off, then i twigged I had only removed 9 out of the 10 nuts, mate was on the floor wetting his pants:rolleyes:
 
You must log in or register to reply here.

Similar threads

R
TD4 2.2 Clutch Pedal Release - Normal Shuddering or Something to Check?
Replies
1
Views
329
Alteredtech
Alteredtech
C
Diff lock stuck after clutch arm
Replies
4
Views
444
Scooby22
Scooby22
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
8
Views
6K
miktdish
miktdish
R
Ex military 90 soft top 1994 - 300TDi conversion
Replies
7
Views
671
ChristopherDailey
C
Corne215
Clutch not releasing
Replies
11
Views
783
marjon
marjon