tankduck

Active Member

• Jan 25, 2011

• #1

Afternoon guys,
did my chassis swap over xmas, is all looking sexy but I got quite a bit of vibration that weren't there before, mainly where sealant and stuff perished and I haven't replaced it as I don't want moisture trapped! I do remember these big chunks of foam inbetween the inner wing and chassis rail, think they were stuck to the chassis actually. Is this common on a 200tdi 90 or does it sound like someone stuck it there?

 

bevhelee

Well-Known Member

• Jan 25, 2011

• #2

Think you'll find they are there to stop vibration

 

jamesmartin

Well-Known Member

• Jan 25, 2011

• #3

i would say someone put it there

 

tankduck

Active Member

• Jan 25, 2011

• #4

Yeah its a tricky one, can't find them on any of the websites and can't find anyone else mentionning them on forums, can't be a good idea to have foam soaking up water and mud surely?

 

L

Litch

Well-Known Member

• Jan 25, 2011

• #5

Sounds like someone did it instead of adjusting the inner wing so it was away from the chassis.

 

dazzx10r

Active Member

• Jan 25, 2011

• #6

well it must be a coincidence then, because mine had the stuff fitted to the lower edge of the inner wing as it goes up against the chassis/bulkhead. Was it an oblonged section about 1 1/2"x 1" and about 12" long?

 

D

Discoandy

New Member

• Jan 25, 2011

• #7

its there om my 1992 and dads 1989