H

harry2012

Active Member

• Apr 4, 2014

• #1

I actually cleaned my Landie today!

8 hours spent washing, clay barring, G3'ing then polishing.

It came up looking a lot better than I was expecting tbh!

Got all the other bits on it too, rock sliders, light bar, steering guard, CB wired in, etc

Also my nice new Pressbrake HD rear cross member is all fitted

And a pic of my light bar and new Angel Eye headlights

One question though. I need to drill my X member to fit my bumperettes, it's 6mm steel, I need to drill some 10 mm holes what's the best way to do it, I don't wanna mess up my nice new x member!

 

Westwood8055

Active Member

• Apr 4, 2014

• #2

Looking good, I'd pilot the crossmember first then do the 10mm holes, just use good gear and you will be fine

 

mlucas110

New Member

• Apr 4, 2014

• #3

Polishing can't help but feel you wasted your time even though is does look nice lol Just use decent drill bits and work your up the sizes and your be fine.

 

H

harry2012

Active Member

• Apr 4, 2014

• #4

Lol! It needed it tbh it was a combination of green and a weird yellow stained colour, and the second hand doors I'd bought were covered in marks and scratches.

 

H

harry2012

Active Member

• Apr 4, 2014

• #5

Well bit the bullet and drilled the X member to fit me bumperettes. Broke loads of drill bits but got through ok

Tidies the back end up nicely

Took some rubbish to the tip, feels much nicer now the things not a **** pit!

 

H

harry2012

Active Member

• Apr 4, 2014

• #6

Also has my Landie been lifted or is it the larger tyres that make it look higher?

 

mlucas110

New Member

• Apr 7, 2014

• #7

looks lifted to me but im no expert