B

Btrower

New Member

• Dec 22, 2012

• #1

Hi I moved the rr out the drive to give it a wash and on full lock to the right the hdc fault came on.i switched the car off and on again the fault went away until i turned the steering again it's only when I get at full lock. Any ideas?
Thank

 

Saint.V8

Dyed-in-the-wool 100% RR Junkie

Full Member

• Dec 22, 2012

• #2

Check your ABS sensors and wiring.....they chaff on the inside of the wheel at full lock wearing through causing ABS, HDC, DSC and EAS faults....

A quick plug into Diagnostics will hopefully show a stored fault code....

It could also be the Steering Angle Sensor....but check your ABS sensors first, I have had this twice due to failed ABS wiring on both front wheels....

 

B

Btrower

New Member

• Dec 23, 2012

• #3

Thanks saint v8 il have a look today and get it booked in to specialist

 

2.0_hippo

Well-Known Member

• Dec 23, 2012

• #4

Btrower said:

Thanks saint v8 il have a look today and get it booked in to specialist

Click to expand...

You don't need any specialists
Just have a look yourself

Pop off the wheel and check the condition of the cabling

 

Saint.V8

Dyed-in-the-wool 100% RR Junkie

Full Member

• Dec 23, 2012

• #5

2.0_hippo said:

You don't need any specialists
Just have a look yourself

Pop off the wheel and check the condition of the cabling

Click to expand...

+1....this was the state of one of mine....

 

Attachments

• 
  Found Wiring.JPG

  440.7 KB · Views: 232
• 
  Chaffed Wire.JPG

  395.4 KB · Views: 269
• 
  Broken wire.JPG

  511.1 KB · Views: 258