Alibro
Well-Known Member
LOL, I did that with one of mine too. Others just cut them off and forget about them. Don't think it makes much difference.First breakdown!
Damper ring detached from the VCU..... glued back on with Tiger seal.
LOL, I did that with one of mine too. Others just cut them off and forget about them. Don't think it makes much difference.First breakdown!
Damper ring detached from the VCU..... glued back on with Tiger seal.
LOL, I did that with one of mine too. Others just cut them off and forget about them. Don't think it makes much difference.
Ok, so after a day of pootling around, minus the hiccup..... I noticed I have a ticking noise occurring over 30mphit is speed linked so guessing that it may well be transmission related.
I have also changed the clutch master and slave but still have a clutch thats on the floor, I saw @Alibro 's modification but surely I shouldn't have to be doing that for a brand new hyd system. I put some penetrating fluid in the lever hole as well.
Did you leave the plastic cap on the slave cylinder? If so there have been quite a few people complaining about the same thing in the past and I never discovered the true issue but some thought the master/slave needs to be hung for a day or two with the master above the slave. The difference between one on the floor and one correct is only a couple of mm so poor quality parts might also be a factor.Ok, so after a day of pootling around, minus the hiccup..... I noticed I have a ticking noise occurring over 30mphit is speed linked so guessing that it may well be transmission related.
I have also changed the clutch master and slave but still have a clutch thats on the floor, I saw @Alibro 's modification but surely I shouldn't have to be doing that for a brand new hyd system. I put some penetrating fluid in the lever hole as well.
LOL! That happens to all of us!So the ticking noise over 30mph.... it was some black masking tape that I used to hold the damper in place while the tiger seal went off, it had detached at one end and was flicking under the car!.... doh
Did you leave the plastic cap on the slave cylinder? If so there have been quite a few people complaining about the same thing in the past and I never discovered the true issue but some thought the master/slave needs to be hung for a day or two with the master above the slave. The difference between one on the floor and one correct is only a couple of mm so poor quality parts might also be a factor.
LOL!Just remove it. Improves the mpg don't you know....![]()
After a certain election result across the pond, I am looking for a sandpit deep enough...Much better not knowing, now you do just bury your head in the sand and it'll go away.![]()