joe27979

Well-Known Member

• Apr 5, 2014

• #1

guys
I'm changing front crank seal and sump gasket.
my pulley shaft has a 1.4 mm groove in it-speedi sleeve or new pulley?
also, please check out pics and comment on any defects

 

joe27979

Well-Known Member

• Apr 5, 2014

• #2

 

jamesmartin

Well-Known Member

• Apr 5, 2014

• #3

looks good to me, either sleeve or new your choice

 

D

divie

Well-Known Member

• Apr 5, 2014

• #4

No brainer, pulley very cheap.

 

joe27979

Well-Known Member

• Apr 6, 2014

• #5

timing case modified, rivets removed:

 

joe27979

Well-Known Member

• Apr 6, 2014

• #6

crank:


rear T seals will get an extra blob of hylomar when fitting new sump gasket:

 

joe27979

Well-Known Member

• Apr 8, 2014

• #7

dressing sump ready to re-fit, the original gasket was well stuck on!!

 

joe27979

Well-Known Member

• Apr 8, 2014

• #8

new water pump fitted, a small smudge if hylomar each side of gasket:

 

jamesmartin

Well-Known Member

• Apr 8, 2014

• #9

nice work and a clean engine inside shows it been looked after

 

joe27979

Well-Known Member

• Apr 8, 2014

• #10

thanks James, it's a shame the new pulley didn't come with a timing notch in it though

 

joe27979

Well-Known Member

• Apr 8, 2014

• #11

dressed and ready to fit with a small run of rtv on each side:

 

jamesmartin

Well-Known Member

• Apr 8, 2014

• #12

joe27979 said:

thanks James, it's a shame the new pulley didn't come with a timing notch in it though

Click to expand...

cant you set it at tdc and add one

 

joe27979

Well-Known Member

• Apr 8, 2014

• #13

jamesmartin said:

cant you set it at tdc and add one

Click to expand...

sure can :tea:

 

joe27979

Well-Known Member

• Apr 9, 2014

• #14

tiny bead of loctite premium rtv on both surfaces, used a couple of exhaust studs in block to act as guides getting pan on square:

 

joe27979

Well-Known Member

• Apr 9, 2014

• #15

crank pulley dog nut size (3brg 2.25 petrol 1978)

 

joe27979

Well-Known Member

• Apr 10, 2014

• #16

sump left for 24hrs, new genuine filter and fresh oil....she now purs again