I have tried looking but can’t find a precise answer, I’m looking at replacing my master cylinder now from research there appears to be a couple of different types of ends that connect to the slave end ?! now my fear is that if I get the one without the plastic collar I’m not going to be able to get it back out if the part fails again ! is it a case of simply taking the old collar off and installing it to the new end ? or do I need to get the one with correct end or is there a special tool I would need to get for the one without the collar , someone must have an answer, I’ve seen people disconnect the pipes and swap them over but ideally I’d like to swap the whole unit over , many thanks any info would be appreciated pictures of the ends in question
