theghostisback
New Member
Hi Does Anybody Know How To Change The Main Headlight Bulb On TD5 03 Reg Facelift Discovery Would be Much Apprieciated 
theghostisback
New Member
As you know with the facelift type you can't get your hand behind the light unit, there is 4 screws 2 of pos drive and 2 of torque type screws i don't want to take the wrong 1's out as i might damage the unit 
bargepower
New Member
Open bonnet. Remove the three screws from the top of the grille, pull grille forward at top and lift away. Undo flap in plastic moulding at the bottom inner end of headlight, remove screw holding lamp unit to body. Remove two torx screws on top of headlight unit, pull headlight forward until mounting pin comes out of rubber grommet in edge of wing, unplug wiring multiplug. Unscrew cover behind faulty bulb, replace, reassemble everything. 5 minute job once you've done it once. Takes longer if you have an "A" bar as that's got to come off first!
RSM72
New Member
Its my first time on the Loony Zone for months and i find what im looking for right away,,, bloody good show. :clap2:
guitaryellow
New Member
guitaryellow
New Member
Many thanks, will give it a go tomorrow, did a fuel pump today, that was interesting first time.
Regards
Ade
Regards
Ade
guitaryellow
New Member
Your tops, many thanks.
1997 Discovery
Active Member
Hello.
I need to replace both the screws and torx bolts along the top of a facelift headlight, as they are all very corroded and need to be drilled out. Screws need drilling out and one torx bolt sheered when trying to undo.
Does anyone know the size of these bolts and screws please. Thanks
I need to replace both the screws and torx bolts along the top of a facelift headlight, as they are all very corroded and need to be drilled out. Screws need drilling out and one torx bolt sheered when trying to undo.
Does anyone know the size of these bolts and screws please. Thanks
