Great work lads keep it up.

Have you fitted the tdci dash etc or modified the bulkhead to reuse the earlier dash?
More piccies please! And keep the updates coming!
Rich

Looks like another good thread to follow, good job so far.

We're using the original dash on the new bulkhead

Sorry for lack of update my dads 110s getting some attention in the garage atm

samc88 said:

Then my brother took the torsion bars off (i think thats what they're called)

Click to expand...

What you are talking about is the trailing arms, the older ones were just beefier I would say.

Fnally some pictures!

The tub is on now and has started being repainted in sand at the back end. Also I managed to fit the new rear bumperettes to the crossmember





The new fuel tank has also been installed as has the seatbox (but only loosely atm until we finish bolting up all of the other bodywork





On to the bulkhead, the gearbx tunnel part of the bulkhead has to be cut out for the bulkhead to fit over the bellhousing properly



Slowly working our way through the wiring



The bulkhead has also been odified slightly to take the original throttle cable and pedal



Wiper motor and heater matrix also installed






Engine was stripped and rebuilt and has now been re-installed (No pics of this but have alink to the rebuild of my own 2.5 in my signature

Done a little more work today, the clutch hydraulics are now fully plumbed in and I started to strip down the front doors ready for repair work(there currently upside down with diesel down the thread holding the door top to bottom as theyre siezed in place