Ian hunt

New Member

• Jan 11, 2018

• #1

Hi I have a 2004 L322 range rover I recently changed a cable in the drivers door and had removed the battery to do so. Now the central locking on the drivers door is not working and the other windows do not operate from the drivers door but they will operate from their own switch.window in the drivers door works from door switch. Central locking locks all doors except drivers door. Tried ECU reset but no luck ? Any ideas

 

Mark Piercy

Well fumbled member....

Full Member

• Jan 11, 2018

• #2

Ay up! Maybe going back into the door would show the problem! Have you nudged any plugs inside or had to remove the plug/wiring harness into the door from the door pillar?
I take it it worked before you did the cable

 

Ian hunt

New Member

• Jan 11, 2018

• #3

Yep. Worked before hand. I have made sure all the connections were seated correctly. Drivers door mirror working. Passenger side not. Puddle light working. Drivers window working. But drivers door not operating other windows. Central locking locks all doors except drivers door. Door locks with key but not deadlock. Courtesy light done not come on when door opened. I had replaced door cable to outside door handle. Battery was disconnected during this operation but might not have been at the start? Can’t remember.

 

Ian hunt

New Member

• Jan 11, 2018

• #4

I did not disconnect any harness from the door pillar as it wasn’t required. Just disconnected those on the door card

 

Mark Piercy

Well fumbled member....

Full Member

• Jan 11, 2018

• #5

Did you have to remove the switch pack from the door you worked on?
Maybe if you did it hasn't connected properly.
I suppose the only way to find out is to revisit the job

 

Ian hunt

New Member

• Jan 11, 2018

• #6

Switch pack wasn’t removed. Only door card and door handle. Have checked connections and all seem properly locked in. Could the switch pack have packed in ?

 

Mark Piercy

Well fumbled member....

Full Member

• Jan 11, 2018

• #7

Only unless it was banged!
Not to say you did a rough job..
Always go back to what you did last.. as a rule