Urban Panzer
New Member
Should be just plug and play, no configuration needed.
Out of interest why you changing it ? not heard of an ACE Ecu being duff before
eightinavee
Well-Known Member
You will probably need to have the upper and lower accelerometers calibrated on Testbook.
martinhollings
New Member
i have had a ace ecu go cost me £45 from cws and it is just plug and play only the one i had had faults loged in it could be confusing if you had a fault in the future
mine just whent dead light on (yellow) would not taulk to nanocom it was cheaper to stick a new one on than mess about with a land rover specialist
mine just whent dead light on (yellow) would not taulk to nanocom it was cheaper to stick a new one on than mess about with a land rover specialist
houdini2012
New Member
Hi
I have an issue with my 03 disco 2 ACE
blowing fuses (15a) even with solenoids disconnected,
Two options now-
ECU replacement or wiring loom diagnostics to find a possible short.
but where is the ECU located?
will update my findings.
I have an issue with my 03 disco 2 ACE
blowing fuses (15a) even with solenoids disconnected,
Two options now-
ECU replacement or wiring loom diagnostics to find a possible short.
but where is the ECU located?
will update my findings.
