M

Mark Ormond

Active Member

• Dec 21, 2015

• #1

3129 road speed missing
3070 glow plug lamp drive
3069 mi lamp drive open
4086 sensor front broken wire
4086 i suspect needs new hub assembly and sensor or could it be just a broken wire.
The others i suspect are minor but good to know what they are.
Out of interest top 3 in EMS when i went to reset them Hawkeye asked if i was sure i wanted to do this, so i left it as it was in case i caused moor trouble.
Any idea why it kind of warned me off
Many thanks

 

jamesmartin

Well-Known Member

• Dec 21, 2015

• #2

clear codes and retry after a test drive, are abs lights on

 

M

Mark Ormond

Active Member

• Dec 21, 2015

• #3

Yes amigos have been on for about 12 mths, would be nice if it were a broken wire but i suspect new hub and sensor i have 2 on shelf. hate ABS and discos just dont get stuck, thats me stuffed next time i go off.
Ok thanks for that will try it in morning

 

jamesmartin

Well-Known Member

• Dec 21, 2015

• #4

tis usually a new hub

 

M

Mark Ormond

Active Member

• Dec 21, 2015

• #5

Its tightening the bloody thing what is about 350 lbf hub nut that is

 

M

Mark Ormond

Active Member

• Dec 21, 2015

• #6

is that 2 or 3 clicks on the scaffold tube

 

sierrafery

Well-Known Member

• Dec 21, 2015

• #7

As said, erase them all go for a ride then check again, it's part of any diagnostic protocol to make you confirm that you want to clear the codes to make sure you are aware of them or to avoid a handling mistake like let's say you wanted to read codes but ended up in the clearing menu, etc... just prompt yes when ever you really want to erase codes and no probs

 

M

Mark Ormond

Active Member

• Dec 22, 2015

• #8

This HAWKEYE is a very good tool to have.
All the faults as you guys said cleared and have remained clear so far.
Just need to work out programing for new key and alter the central looking to all doors
Thanks Lads