Hi all
was just wondering if anyone knows of any bumper brackets to put bumper back where it should be after a 2inch bodylift.
had a scout round on forum and lots of talk of needing them but im wondering if anyone sells them
many thanks

Can honestly say that i havent seen any either. If all else fails I can re-weld the brackets a little lower on the bumper to lift it up if it helps matey. I will probably end up doing that on mine until i finish the winch bumper fabrication, which come to think of it isnt started yet lol

Come to think of it I have some 100x60x6THK RHS left over from the sills. You can weld this to the chassis above the mounting points of the bumper and relocate the bolts upward 2" and still maintain structural integrity. Might be easier.

sounds wicked mate.cheers.