sierrafery
Well-Known Member
yes...it has the non-cdl loom...you need a proper loom or hardwire the switch into the correct plug... if you are up to that and you have RAVE i'll tell you how
sierrafery
Well-Known Member
Check with multimeter which "leg" of the switch has earth on it(it must have it via fixing, if it's not give earth to one leg)), connect a wire to the other leg with a spade connector and splice with this wire into C0681 pin 7(black/blue wire), (before that give an earth to pin 7, put ignition on and see if the warning lamp comes on) in the quite unlikely case that i doesnt work go to C0761 pin 1. That's all
you find the connector views and pin disposals in RAVE Electrical library - connector views...concentrate to not mix plugs or wires
you find the connector views and pin disposals in RAVE Electrical library - connector views...concentrate to not mix plugs or wires
Last edited:
thebiglad
Well-Known Member
Hi,
I have a copy of rave, your help would be greatly appreciated again, hoping this will allow me now to get to the bottom of my rumble issue. Help away
If you are thinking of using the CDL to lock the diff so you can remove a prop as part of a transmission diagnostic, you don't need the wiring/switch etc as it can be manually selected and deselected from underneath.
