Ahaggar

Active Member

• Apr 3, 2011

• #1

Hi

Funny things happen with my Disco.

The far side Airbag is inflated completely, the driverside is on normal high.
While driving she eventually levels out on a proper high.

New Bags, new Sensors, no faults shown on Nanocom.
It is possible to set the high with the Nanocom and it will stay on that high until I drive again.

I`m really confused

THX Markus

 

thought it was mine!

New Member

• Apr 3, 2011

• #2

sounds like it needs a reset from wat i have read.Needs to be plugged in and hieghts adjusted with spacer blocks(i think).So ride height sensors are calibrated to car

 

Ahaggar

Active Member

• Apr 3, 2011

• #3

OK, I`ll give it a try with the blocks tomorrow but it is adjustable with the Nanocom.

 

thought it was mine!

New Member

• Apr 3, 2011

• #4

can't answer that one sorry! but someone will with any luck

 

B

ben.suffolk

Active Member

• Apr 3, 2011

• #5

I made my own blocks out of a bit of 2x2 inch fence post I had in the garage.

 

Landybandy

Active Member

• Apr 3, 2011

• #6

Nanocom will re-calibrate them, I'm quite sure of it & I think the height is 33" from floor to arch. Hope this helps. Did you change the height sensors yourself by the way? If so hope you disconnected the battery! Cos if you didn't the old duck needs re-calibrating.

 

sierrafery

Well-Known Member

• Apr 4, 2011

• #7

First of all try to swap the sensors...disconnect battery before that. U might get lucky cos the sensors will work on the unused side then....if no joy recalibration with nanocom will do it(unless it's an ECU issue)

 

Ahaggar

Active Member

• Apr 4, 2011

• #8

The Story goe on!

Today it`s rainy and not too cold. Everything works great. when I Yesterday left the car it was like the Titanic. Today in the Morning everything was great and still is.

Is that a sign that my car likes british weather or just a bad Connection somewhere?

 

Ahaggar

Active Member

• Apr 5, 2011

• #9

Solution found!

The Connectors around the Compressor needed some attention. Every electric connector treated with WD 40, Prob solved