Junglemist
New Member
I have an LT77 gearbox with the slave cylinder removed. With the slack taken out by pressing in on the push rod how far should the push rod stick out past the housing? Thanks.
jamesmartin
Well-Known Member
about 1 cm
Junglemist
New Member
That's what I was afraid of. I just installed an engine and somehow the clutch fork isn't right and the push rod will go all the way inside the housing with no resistance. The push rod is still connected to the fork correctly, so it must be the bearing or ball socket.
jamesmartin
Well-Known Member
youve not got spare release brg at the side of car ,or it can be tricky locating lever properly with clip behind pivot
Junglemist
New Member
I was able to move the fork around correctly and got the slave cylinder back on and bled. Thanks for the information on the spacing.
