doobreydog
Active Member
Its there somewhere.... Will try and get pics off my phone for the doobreydog definitive cure to all cracked chassis mounts.
All fixed now, The nut had broken loose so a new plate and a bit of welding and all is now well. Quite a easy job to do if anybody else has the same problem?
I am getting a loud crack from the rear, and need to do this job, any chance of some pics of where you cut open the rear floor, PM me if you need my email addy......Mark
Chaser
New Member
Amusing, but kinda proves my point and yes I willTry asking here Land Rover UK Forums - Powered by vBulletin
take off the rear wheel, you will see a stabiliser bar that goes from the hub to the cross member near to the diff mounts. remove this bar and you will see where the crossmember bolts up at the end ... check to see if this is tight .. and I mean really tight.. if not undo the bolt and poke a long pointy drill bit up and through the rubber grommet in the boot floor.. there are loads of them I cant remember which one it is.
under that grommet is the nut inside the subframe.. tack weld it back and rebuild
that should fix the problem
or look in the Q's and A's bit.
under that grommet is the nut inside the subframe.. tack weld it back and rebuild
that should fix the problem
or look in the Q's and A's bit.
There is a row of grommets under the carpet behind the rear seat. They are all in between the spot welds for the chassis so alls you have to do is find which grommet is above the bolt you need to repair take out the grommet and with a pair of tin snips cut a x in the floor where the hole for the grommet is. Fold back the metal and weld the nut back in place (or in my case a new plate for the nut to attach to) Fold the metal back down and put a couple of tacks of weld on to hold it together then put the grommet back in. If you still need a photo pm your email and i will send you one.
