Hi after doing egr mod and cleaning manifold brake pedal seems to go hard any ideas of why
The pedal is normal for say two pushes then becomes hard going to have a better look today just to make sure not disturbed anything elseThis is very strange as removing the EDR should not have affected the brake pedal feel. My brakes are the same as before.
If you have 'lost' the servo then braking would be hugely affected and you would have to press the pedal tremendously hard to stop. Very unsafe.
But you say it stops OK.
Did you perhaps remove or plug the wrong braided vacuum pipe?
S.
Thanks for your help found the problem was the braided pipe on the tee piece which had split under the breading the pipe had lost it's elasticity and had gone hard cut it back and were back to normal wounder how long it had been like that thanks again for the help chapshi try the 4 mm tube that lies over the gearbox and rubs on it thus produceing a hole in the back of it. It happened to me follow the tube from the servo down to the pump and there is a tee piece it is that tube that comes of there and goes down to a conection next to the retard tube it is very difficult to see where it goes so be care full I took the air inlet system of to see it better and they sell the 4 mm tube on ebay
Found the problem down to the braided pipe on the tee piece had a split in it under the breading cut the pipe back and were back to normal wounder how long it had been like that thanks again chaps for all your help![]()