MJI

MJI

Well-Known Member
Before I buy a new one, does anyone have a spare or unusd pressure transducer I can try to make sure it is definately that?
 
You still after the part mate? I got the block so could get it off and send it to you if you want.
 
Oh well time to buy a deep drive 27mm socket as last time I fitted a pressure sensor was after rebuilding so sittting on a piece of card behind the car (me and valve block).

By then should be warm enough I hope
 
Got the socket, drizzle and temperature has dropped a lot.

Will have to watch the weather when I have a good half hour of warm and dry
 
I just pulled the pipes out the spare to get a spanner on there when I realised I didn't have a deep 27mm, tried to swap my wheels today till the high speed winds and snow came and put a stop to it, plus this disco has ..23mm nuts.. thinking they must be imperial.
 
Still not working, suspect presure is actually low.

One last test is going to be to measure pressure when unplugged in case problem in loom.
 
Have you tested it with Hawkeye? Any codes, will it perform the ACE test?
But quite simply beyond the basic plumbing of it I'm not too knowledgeable on the whole system, I've got other parts if you need to try anything else though.
 
Jamiegreen said:
Have you tested it with Hawkeye? Any codes, will it perform the ACE test?
But quite simply beyond the basic plumbing of it I'm not too knowledgeable on the whole system, I've got other parts if you need to try anything else though.
Click to expand...

yes no no
 
You must log in or register to reply here.

Similar threads

MJI
Disco 2 Closed loop pressure not under control ACE
2
Replies
21
Views
1K
MJI
MJI
G
Disco 2 ACE Problem
3 4 5
Replies
80
Views
9K
sierrafery
sierrafery
T
Ace problem !!
Replies
3
Views
1K
sierrafery
sierrafery
R
Orange ace light
2
Replies
23
Views
4K
Stanleysteamer
Stanleysteamer
Andy Warren
Disco 2 ACE pipe leak
Replies
12
Views
2K
Andy Warren
Andy Warren