W

Webley1991

Well-Known Member

• Jul 20, 2013

• #1

I noticed today that the angle iron support between the chassis and bulkhead outrigger were missing on both sides of my chassis. They ends were still attached (until I ground them off). Is it worth replacing them or not?

Thanks for any info.

 

Rattlegun

Well-Known Member

• Jul 20, 2013

• #2

I wouldn't go out of my way to do it, maybe if it were all in bits. I dont think series twos had them at all?

 

johnny curt 1

Well-Known Member

• Jul 22, 2013

• #3

series 2 didnt have them as said and i didnt bother putting them on mine during the restoration and the MOT fella didnt say anything .................so why bother as long as theres no sharp edges

 

dominicbeesley

Well-Known Member

• Jul 24, 2013

• #4

I just welded one back on mine that had been ground through. What is the purpose of them, strength, crash strength, vibration? D

 

johnny curt 1

Well-Known Member

• Jul 24, 2013

• #5

dominicbeesley said:

I just welded one back on mine that had been ground through. What is the purpose of them, strength, crash strength, vibration? D

Click to expand...

i cant see any point in them structurally apart from being an extra place to get grass crap cow**** and other tinworm carrying substances to settle in to eating the fookin outriggers off a lot quicker than without :doh::doh:

ive seen a mates landy with carrier bags and fekkin allsorts mangled round them