T

tulipandthistle

Active Member
Hi All,

My 03 Disco Td5 had coils fitted when I bought it. All the stuff was still in place so today I took the coils and put airbags in.

I activated the SLS in the Slabs menu. The ride height is 152 on the nanocom.
Now it seems to be working, alright. it lowers a bit when I switch off the engine and it goes up a bit when I the car starts. The SLS light is flashing as it rises but when it is level the light stays on.
Nanocom and Hawkeye don't read any fault codes.

The other button for rising the suspension doesn't seem to do anything either.
What am I missing?
Any ideas?
 
I thought the SLS light flashed when it was lifting to ORM height and then stayed on when it was at ORM height. What happens to the light when you drive at speed?
 
Unplug the ORM switch and see if it changes something or not... if not it seems that the management is stuck in ORM which looks very like an ECU fault
 
I've got it... I can't see in that video if the ORM warning comes on or not for self test ... that behaviour of the SLS warning is not normal at all, it behaves like the ORM warning should when ORM is selected... go with nanocom in SLABS - Outputs and force the SLS and ORM warnings on for test see what happens
 
OK, both lights work with nanocom. They also work on the right button. Tested the buzzer as well, worked too.

What I did notice is that the car didn't raise itself while the nanocom was in it and the light went off. The light remained off after I started the engine and drove a bit with it.

Can it be that my target heights are set too high or that the calibration went wrong?
 
No, it's part of the SLABS but there are cases when the SLS side fails while the ABS is OK.. or vice-versa
 
Out of curiosity how did you set the height when you calibrated the ride height sensors? I used the Lynx diagnostic unit on mine and placed 62mm blocks under the bump stops as a reference. It seems to have worked ok. Are they new ride height sensors?
 
I could see mine working on the lynx but when I took the old ones off the bottom bushes had disappeared altogether. I don't think they are the source of your problem though.
 
brianconwy said:
I could see mine working on the lynx but when I took the old ones off the bottom bushes had disappeared altogether. I don't think they are the source of your problem though.
Click to expand...

I plan to replace a few bits and bobs when I have it all working. They must have taken it out for reason. If I find the fault everything will be put in brand new.
 
Fixed!!!
I think using nanocom and hawkeye isn't advisable. Lol

Use one of them and stick with it.

I used the nanocom to check settings, transport mode was enabled eventhough I disabled it yesterday.

Tried to disable and write settings but no joy it enabled again. Switched it off. Went to calibration process again and write settings, after double checking transport mode.

All working now!!
 
You must log in or register to reply here.

Similar threads

A
SLS nightmare! Please help
Replies
0
Views
338
amills0946
A
Roving4life-
SLS chime after air strut suspension removal
Replies
2
Views
494
Roving4life-
Roving4life-
mad85
Disco 2 Air suspension amber light wiring
Replies
10
Views
909
sierrafery
sierrafery
T
Engine management light on.
Replies
7
Views
481
gstuart
gstuart
R
SLS Warning lights after sensor change
Replies
2
Views
1K
sierrafery
sierrafery