sierrafery said:

According to the book both those relays are getting ignition feed on the coil from the ignition load relay K127(C2007) no other relay involved, then when the swicth closes to earth the relay closes too.... it's the same for cooling fans and blower too

Click to expand...

Dippypud said:

Is the heater fan speed doo dat a standard rheostat affair ?

Click to expand...

The Mad Hat Man said:

fixed resistor network, but fans dont work on III, which they should even if resistors are buggered,

Click to expand...

Dippypud said:

Yeah that's where I was thinking ...

Click to expand...

sierrafery said:

Electric troubleshooting manual, connector view C2007/K127(ignition load relay), you have to check on fan's and blower relay's coils(#86) for 12V with ignition on then see if they get ground from the switch on 85...if no 12V route a wire from the K127 power output to the relay's coils(86) cos maybe the feed is interrupted in a header or something cos K127 must send the voltage from F6 sattelite fusebox to both AC relay's coils

Click to expand...