eddiecos

Active Member

• Apr 19, 2014

• #1

any advice on the size,difficulty and cost of replacing the ace pipes on a disco 2 03 plate as ive discovered 1 is leaking before it goes into the valve block near the front of the car? Looks quite difficult going by a quick search on the internet.

 

jamesmartin

Well-Known Member

• Apr 19, 2014

• #2

3 of the 4 pipes from front of block are high pressure 1 low which can be repaired with hose clips and hose for a while,the other 3 will need replacing pipes are about £100 each ,new pipes from pump come in 2 pieces to aid fitting

 

eddiecos

Active Member

• Apr 19, 2014

• #3

Better to be done by a garage then?

 

jamesmartin

Well-Known Member

• Apr 19, 2014

• #4

have a good look at rear pipes where they go over chassis to ram often rusty there ,if your going to disturb block may as well replace all that are not in very good condition

 

Last edited: Apr 19, 2014

eddiecos

Active Member

• Apr 19, 2014

• #5

doing a bit more reading up i think i might just remove it all together and fit the std anti roll bar kit

 

jamesmartin

Well-Known Member

• Apr 19, 2014

• #6

ive removed quite a few ace systems and fitted roll bars ,seem to handle well enough,most say they cant tell any difference

 

eddiecos

Active Member

• Apr 19, 2014

• #7

jamesmartin said:

ive removed quite a few ace systems and fitted roll bars ,seem to handle well enough,most say they cant tell any difference

Click to expand...

thanks for the advice