B

bigjak

Active Member

• Aug 17, 2016

• #1

Can someone with an early 110 post a photo of their lower seal?
My P channel looks too high and my rubber seal looks too low, in fact it comes out under the door!!
I could lift the rubber seal a bit but I lined the holes up and drilled them through the middle of the metal insert.
Please help.

 

B

bigjak

Active Member

• Aug 17, 2016

• #2

What I have

 

Attachments

• 
  image.jpeg

  283.5 KB · Views: 135
• 
  image.jpeg

  268.7 KB · Views: 136

Al2O3

Well-Known Member

Full Member

• Aug 17, 2016

• #3

Presumably the old seals were the same profile as those new ones? So the early 110's had seals that attached to the sill rather than the door? Not helpful, mate I know. I'm just thinking out loud!

 

B

bigjak

Active Member

• Aug 17, 2016

• #4

No old seal to check against. Perished and sills were rotten and replaced. So starting afresh.

 

M

mattyguk

New Member

• Aug 18, 2016

• #5

If I remember correctly the P section on mine (original I believe) faces the other way? With the rolled top facing out and rubber pushed into it? I'll check and see if I've a picture.