G13SJC

New Member

• Apr 29, 2007

• #1

This morning, my clutch slave cylinder mounting bracket broke whilst I was using the clutch pedal.

I have repaired the bracket, but now have a query:

Can the pushrod on the slave cylinder be compressed to allow me to fit it onto the clutch actuating arm.

Its currently at its full extent of travel and will not depress.

Any ideas to get me mobile for the morning??

Regards

Steve

 

S

slob

Well-Known Member

• Apr 29, 2007

• #2

try undoing the bleed nipple a tad

 

G13SJC

New Member

• Apr 29, 2007

• #3

slob said:

try undoing the bleed nipple a tad

Click to expand...

Thanks for reply fella, Where would I find that?? It looks like a sealed plastic system

The only thing I can seem to remove is the reservoir cap.

Any ideas??

 

S

slob

Well-Known Member

• Apr 29, 2007

• #4

dunno where it might be or whether it is indeedy a seal system, you could try the res.cap

 

S

sparkyjohn5

New Member

• Apr 29, 2007

• #5

If it's pre 2001 it's a sealed system,after that I am not sure, pre 2001 you should be able to push piston back but if you have lost any fluid you might need a new unit @ around 44 quid (dealer price).

 

G13SJC

New Member

• Apr 29, 2007

• #6

sparkyjohn5 said:

If it's pre 2001 it's a sealed system,after that I am not sure, pre 2001 you should be able to push piston back but if you have lost any fluid you might need a new unit @ around 44 quid (dealer price).

Click to expand...

Thanks very much guys...

I went out 2 hours ago, removed the reservoir cap and pushed the rod back. Its all back together and drivable again.

Just covered 20 miles and all seems well. I repaired the bracket using a trailer socket bracket. I'll get a new one ordered tomorrow.

Thanks again.

Steve