[iannotts]

eye thats um, just drill the rivet and put new ones in? could do with the wings out the way at the moment.

Tis all new the defender stuff, used to series, rangey and disco

 

[pos]

'Ere pos.. did ye knock over some rollers and mash them a bit?

Precisely that

 

[bustersbus]

eye thats um, just drill the rivet and put new ones in? could do with the wings out the way at the moment.

NO! If ye take a moment and clean one off ye'll find that there's a plastic pin goes up throught the middle off them. Just chap it out with a panel pin or simmilar Sometimes ye might lose the plastic pin but ye can soon enuff get some new 'rivets'

 

[bustersbus]

Precisely that

Ah thought so It's a bastid when that happens, but ye'll know better the next time

 

[iannotts]

NO! If ye take a moment and clean one off ye'll find that there's a plastic pin goes up throught the middle off them. Just chap it out with a panel pin or simmilar Sometimes ye might lose the plastic pin but ye can soon enuff get some new 'rivets'

ooo busters top tips stike again cheers mate will have a go if i get chance tomorrow, its the big lift. engine and box are going back in

 

[pos]

Yeah they shattered to pieces!!!

 

[iannotts]

Yeah they shattered to pieces!!!

Didnt ya hold them back with grease and CAREFULLY put the spider in?

 

[bustersbus]

Yeah they shattered to pieces!!!

Aye, that happened tae me first time round. All ah did was use a couple of me old rollers to replace the ones ah fecked. If ye noticed in me 'how to' ye'd have seen ah packed the cups pretty full, that was tae stop the buggers fallin' over and make sure ye haven't fitted the grease nipple until the end

 

[pos]

Yeah those grease nipples are awkward gits. Its not until you're trying to bray the spider out that you notice its in the way! I'm just waiting for the front lower one to snap off now when it hits the flange! There was no where it could go that was safe though!!!