[UnitLandy]

How'd you get these clips off?

 

[Mark Piercy]

How'd you get these clips off?
View attachment 347778

Normally they end up being destroyed so have a couple small jubilee clips to replace them
You'll find one end can be levered off

 

[Datatek]

I used something like a Dremel very carefully.

 

[UnitLandy]

Are they factory fitted. If that's the case then the fluid likely has never been changed.

I'll see if I can peel the tabs off with a thin flathead screwdriver. The tabs are around the back which makes this a nightmare...

 

[Datatek]

Are they factory fitted. If that's the case then the fluid likely has never been changed.

I'll see if I can peel the tabs off with a thin flathead screwdriver. The tabs are around the back which makes this a nightmare...

Unbolt the reservoir

 

[Mark Piercy]

They could be factory. Be careful twisting them incase you break the reservoir ends

 

[RangeRoller dt]

They can be taken off with like a pliers and screwdriver. They need a special tool to clamp them on better off replacing them. They are stronger than usual clips but old by now. Check other end see if it been done already tuther side or if it can come off without disturbing them.

 

[brianp38dse]

Those type of clips can be tightened up with ceramic tile nippers if any needs to.