If they've rotted, some heat, oil and a good pair of mole grips.
Or cut the buggers off with a grinder
Then cut and make the old bolts flush and drill then out to fit bolts if you're using the part again
Last edited:
If they've rotted, some heat, oil and a good pair of mole grips.
Or cut the buggers off with a grinder
Then cut and make 5be old bolts flush and drill then out to fit bolts if you're using the part again
Are M10 x 100 bolts long enough ?
Γ good question, get in there lad and measure them.
As a rule, any bolt length should leave at least 5mm sticking out of the nut once it's tight
As a rule, any bolt length should leave at least 5mm sticking out of the nut once it's tight
Nice oneΓ good question, get in there lad and measure them.
As a rule, any bolt length should leave at least 5mm sticking out of the nut once it's tight
, I've just snapped a bolt so this is going to be fun, only got hand tools.Just measured it at 5-6 cm which translates to 50mm so they should be enough.Γ good question, get in there lad and measure them.
As a rule, any bolt length should leave at least 5mm sticking out of the nut once it's tight
I believe standard are actually M12 heads as I had an M12 socket get stuck on the head of the bolts when it snapped .
Obviously this is totally different if the exhaust was changed in the past and someone used different bolts.
However M10 bolts did fit in my case.
100mm are far too long
Try 50 or near about
