try and remove the belts and hand check the pulleys and water pump. If in doubt, run the engine briefly with all removed to verify your engine doesn't have my issues.....good luck! 
good question! Grrrrrrrrrrrrrrrrrrrrrrrrrr
dont get a britpart or allmakes, they are sh*te... Better off with febi, gates or dayco if you get them. I ordered the full kit belts and pulleys. Buggered after four months. Grinding pulleys and cracked belts.....
ovalandrover
Well-Known Member
renew them both for the sake of a few pounds and it might save you doing them again in the near future
+1
I had one go bad on me and resulted in the bearings collapsing. Not what you want in the middle of nowhere in the winter. (Yes my engine bay was filthy. It has been cleaned since this photo was taken)
Oh heck, I can't remember I'd have to check the invoice. I think they were around 20 each but couldn't say for sure.
ovalandrover
Well-Known Member
Another common fault is the angle bracket that holds the idler pulley can break and cause problems
No need to remove rad. Note belt run before you take it off. Be careful springing tensioner.
