[currymunster]

I've managed to mash the thread on the big m20 thread on my F/N/S radius arm!!!

Does anyone know if the thread is part of the arm? Will I have to change the whole arm???

 

[Robbo5833]

10 out of 10 for effort! Will it not clean up with a file?

 

[currymunster]

10 out of 10 for effort! Will it not clean up with a file?

Tried that to no avail - When I took off it unscrewed till the stud bit was just clear of the nylock bit - then just round and round stripping the thread untill I realised Wow I've turning this for a while it must be nearly threre?
Alas no - out came the pry bar same time as unscrewing -
Result _ stripped thread !!!!!!!!!

 

[jamesmartin]

another arm ,usually nut goes

 

[currymunster]

another arm ,usually nut goes

Thanks James,
My nut has all the studs thread in it. When I put it on it for the MOT it went so far and no further so I gave up an crossed my fingers for MOT. Ordered new Nut and hoped for the best!!!

Any one got a radius arm near kent going??????????

 

[Robbo5833]

I've got one in Peterborough