Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. N

    Glow plug light

    Hi Guys Ever since Ive had my 2003 td4 my glow plug warning light has come on for a few seconds when ignition switched on and then extinguishes. Now the LED warning light and glow plugs does not come on at all even in cold weather. Had a look at relay and found that I'm getting battery...
  2. N

    Crankshaft pulley torque

    Hi all To tighten the crankshaft pulley retaining bolt Haynes says torque to 100 nm then angle tighten in three stages, 60,60 and then 30 degrees. Is there a point to this or can I just do 150 degrees ? Some people have said that the tightness of the bolt holds the pulley on and does not need...
  3. N

    Jatco jf506-e info please

    Hi Guys Can anyone help with a couple of pages from ATSG manual for the JF506-E automatic gearbox used on Freelander 1. I'm looking for page with figure 45 (no reverse slips forward) and figure 46 and 47. thanks
  4. N

    Ball joint boot

    Hi all Passed Mot the other day with my 2003 TD4 with advisory about front lower suspension arm ball joint boot deteriorated but preventing the ingress of dirt. Has anyone just renewed the boot. Saw boots on Track Control Arm Boots, Larger Track Rod End Boots, Larger Tie Rod End Boots...
  5. N

    Rear brake pipe flexi to cylinder

    Mot advisary to renew rear brake pipes. The short ones between flexi pipe and brake cylinder. Measured them up and found that the union on the cylinder I could get a 11mm spanner on but the union onto the flexi pipe it was a 10mm. That was the same for both sides.Whats going on. I thought that...
  6. N

    tailgate lock problem

    Hi Guys My tailgate lock motor is knacked. How do I open the door.I've got the rear trim off and all and can see the motor. I've heard that you can release the lock by using a tent peg .Where do I position it and do I take out the bottom screw holding it ? any help appreciated
Back
Top