Recent content by Springbok

Hi KarelP38 That Joke thread was hillarous, these poms have a brilliant sense humour, if you find let me know Thanks

Hi all Can anyone tell me where the air intake for air suspension compressor is situated so I can clean or replace, The Disco 2 was behind the left hand tail light. I am sure this filter if not cleaned or serviced causes premature failure of the compressor. Thanks in advance :confused: Ray

Hi The Big Lad I think the sensor you are referring to is the crank position sensor on the fly wheel that and the clutch and the flywheel have all been changed, I have got a plug and play unichip installed which helped but did not cure the problem, Some of the guys mentioned the air flow meter...

Hi Big Matt My Disco is fully serviced since I have owned it. it has done 244000kms I got it at 160000kms

Hi Guys Thanks for the imput I changed the Air mass meter last week, no change, I have already removed the EGR completely and removed the valve out of the pipe. lastly its a manual. Ray

I have a 2000 TD5 ever since I have had this car going on 4 years it struggles to pull off in high ratio, I have done many things to the vehicle, New ECU, new Injectors, new internal Injector harness, Cyl Head Recond, changed Turbo, Throttle pedal change, unichip,new crank sensor, some more too...

Thats a shame because the HID conversion is far safer than the standard lights on a Disco 2. Although I have a self leveling suspension on my ES I also have an adjustment for the lights on my dash board Ray

Hi Plasek The kit I used was from China, since that posting there are many other kits on the market and cheaper, I dont think it matters which one you use, it must be an H4 bulb which gives you both hi and low beams HID Xenon. These are readily available in South Africa so I imagine you will...

Hi Your suspension will drop if you add weight but it should regain its normal height with the engine running and the doors must be closed it should take about 30secs to a minute. :) Ray

Hi I have just fitted a HID Xenon kit to my 2000 TD5 highly recommended,bulbs run cooler than standard and you can see at night. Ray

HI GUYS I have a 200 model TD5 and I fitted a HID Xenon kit for about 100 pounds (R1700 ZAR) What a difference I can now see at night it takles 15 mins to fit and you can reverse it in the same length of time. Ray

Hi Everybody, I would for interest sake like to know the mileages of a TD5 without rebuilding I have a Disco2 TD5 22700kms (141000miles) a friend has a 2003 facelift with 276000kms (172000 miles) Both are running perfectly except mine has had a head recon. I would be interested to know...

Hi Guys Does anybody have any information on a variable nozzle turbo (VNT) fitted to a TD5, apparently this sorts out the disc 2 turbo lag plus plus Thanks in anticipation

Hi Stuart C I have had a similar problem, which the engine management system detects a problem and the engine goes into limp mode which does not allow you to rev over 3000rpm, try somebody whos got a computer program that can read the fault codes and diagnose the problem and reset the...

HI I would say there is something wrong with the compensation ventilation hole, air does not seem to be able to replace the fuel used. Ray