Recent content by Jonny90Boggs
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Cheers for the advice it seemed to be the third fuse was burnt out and then it work. Might not be connected but it's working now
-
Hi everyone I am have a few problems with my lights wiring but at the minute I'm struggling with fog lights. It's a 200tdi wiring bulkhead loom 19j chassis loom.
The is 10v going across the switch but at the other end of the bulkhead there is only 0.5v.
I check the bulb and unit it's working...
-
Final started the engine after a year or two of being rebuilt. However after it was turned off oil sprayed out of the top oil joint into the oil filter (in picture). I tightened it as tight as I could but it did it again.
Any ideas? Could it still need tightened more? Help!
-
Hi I need help. I have a 1987 ninety 19j with 200tdi bulkhead wiring loom:
1st. When I connect the battery a relay turns on and the dash lights come on. Is that right?
2nd. What order is the ignition barrel suppose to be wired. There's a brown, white, white/red and white/orange wires. What...
-
i have just put a 200tdi wiring loom into my 1987 ninety so I had to use a 200tdi ignition, Lucas ssb300. I am not sure what wire I need to connect to each terminal. There's 4 wires brown, white+orange, white+red and white.
-
They don't have a online shop. You have to phone them or go to the shop but they are very helpful.
-
Thanks good to learn more about land rovers all the time
-
Could anyone please explain what this axle is and how it's different from a normal one :)
-
I'm in NI too and I get most of my stuff from BLRC.
-
-
-
-
http://m.ebay.co.uk/itm/271637912171?_mwBanner=1
-
Are these seats being sold by anyone on here.
-