mark666freelander
New Member
- Posts
- 221
- Location
- aberdeen
ok so i had the maf out today and noticed that the pipe from the maf to the turbo just slides on and off of the turbo should there not be a clamp round this ?
mark
mark
turbo hoes clamp ?
- Thread starter mark666freelander
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Skynet
Well-Known Member
- Posts
- 1,197
- Location
- Melksham, Wiltshire
is it because it has negative pressure rather than positive?
mark666freelander
New Member
- Posts
- 221
- Location
- aberdeen
i see what your getting at but it seems to loose a fit to seal ? if this was the case would this not allow un metered air into the engine
mark
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
if this comes off you will get a wooshing sound like other have had
mark666freelander
New Member
- Posts
- 221
- Location
- aberdeen
i can hear the turbo spooling up and a the noise that the turbo makes but just seems odd that its just a push fit. don't suppose it would hurt to stick a clamp round it just for piece of mind ?
mark
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
at least if you do put a clamp on you will know it will not come off
sijwhite
Active Member
- Posts
- 625
- Location
- Shandon, Argyll & Bute
Mine doesn't have any clamps either. It stays put.
Similar threads
Freelander 2 (LR2)
Turbo coolant return pipe
Freelander 2 (LR2)
Turbo