TC and HDC Burn constand

Land Rover freelander 2.0 TD4 3-manual 2002 TC and HDC come on after a while driving, and go off when you touch the brake.
Then sometimes again but also not.
Remschakelaar replace (stood up Bulletin Board as a possibility).
Now they're going burn after a while, but no longer from braking.
Only when I stop the engine restart, they masterfully put off the rest of the trip out. On-board computer fine with the following messages.
Motor has failed: P1E00 Can Bus, ABS has C1151disturbance Can-data, data C1220 C1221 gear selection, failure probability, brake pedal switch, electrical failure (this reset) does anyone know Council and what do these codes.
Gerard

Ummm, faulty brake pedal switch? Replace it!

Brake switch replacement guide over here

http://www.landyzone.co.uk/lz/f69/3-amigo-brake-light-switch-replacement-guide-125617.html

welcome to the forum

Thank you, but brake switch is replaced . but the same problem

Grat said:

Thank you, but brake switch is replaced . but the same problem

Click to expand...

yerrs. COULD be something ABS related..

do you have a 'long pedal'..my amigos did this briefly and the brakes were very soft so I stopped and stamped hard on em and the rears seem to have adjusted themselves and all is well again.

Quite a selection of fault codes there. Maybe some are old.

I'd clear them and read them again after the next TC/HDC light event.