CB Radio connection

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

Side-show-bob

Active Member
Posts
195
Hi all

I am fitting my CB radio tomorrow, I am mounting it where the front sunroof switches would be in the roof, I was going to take the power from the internal light but when my freind did his he found that the supply was insificant. Can anyone recommend another place without going all the way back to the battery, can I connect to the stereo permanent feed? Will the supply be sufficient for both the radio and the CB?

Also dose anyone know what size fuse I should be using for protecting the CB radio?

Cheers

Rob
 
I'd be amazed if it drew more than an amp and a bit even when transmitting. Unless you have some turbo-nutter booster that is :)
 
tried wiring my mates cb in by joining into the int light but once we removed the roof console we thought the wiring for the light was to thin to join into so decided to run a wire from the cb that was screwed to the roof console through the map holder then down the A post cover to the wiring loom behind the kick panel and along the loom through the bulkhead to the battery we also fused it aswell, sounds a lot of work but there was nowhere ells to pick up from even the wires to the sun roof switches were the same as the int light wires but anyway it works ok, mite do mine the same way once i can buy a smaller cb to fit into my map holder, can't fit it in the roof console as my sun roofs are manual ones :eek:
 
cornish rattler said:
tried wiring my mates cb in by joining into the int light but once we removed the roof console we thought the wiring for the light was to thin to join into so decided to run a wire from the cb that was screwed to the roof console through the map holder then down the A post cover to the wiring loom behind the kick panel and along the loom through the bulkhead to the battery we also fused it aswell, sounds a lot of work but there was nowhere ells to pick up from even the wires to the sun roof switches were the same as the int light wires but anyway it works ok, mite do mine the same way once i can buy a smaller cb to fit into my map holder, can't fit it in the roof console as my sun roofs are manual ones :eek:
Click to expand...
What I did with mine was I put the radio in the map pocket, by losening the screws but that ment there was a gap around the thickness of my finger so I drew around the cb and cut the hole and fits pefectly now and as said earlier just tapped in to the light circuitthen earthed to one of the bolts holding the light in
 
landy1uk said:
What I did with mine was I put the radio in the map pocket, by losening the screws but that ment there was a gap around the thickness of my finger so I drew around the cb and cut the hole and fits pefectly now and as said earlier just tapped in to the light circuitthen earthed to one of the bolts holding the light in
Click to expand...

yeah mines an old school one ( cobra soundtracker 80 ch ) great rig but a bit too big to put in places without damaging anything to make it fit and my mates is a newish midland with the buttons on te mic aswell is the rig and very slim when i get one will fit it where you have fitted yours, i have measured it and it looks like it will go in without to much messing about :p
 
cornish rattler said:
yeah mines an old school one ( cobra soundtracker 80 ch ) great rig but a bit too big to put in places without damaging anything to make it fit and my mates is a newish midland with the buttons on te mic aswell is the rig and very slim when i get one will fit it where you have fitted yours, i have measured it and it looks like it will go in without to much messing about :p
Click to expand...

yeah go for it mate CB I have is a Midland Alan 121 that has the up and down on the mic aswell good radio
 
The Mad Hat Man said:
or yu can fit it on th etop of the dash - between the grab handle and the instrument binnacle.
Click to expand...

yeah i did put it there loosly ( cobra ) just to see what it was like but i didn't really like it there so i think i will go for the map pocket idea as with the up and down buttons on the mic ( midland ) i won't need to look at the set as much.
 
cornish rattler said:
yeah i did put it there loosly ( cobra ) just to see what it was like but i didn't really like it there so i think i will go for the map pocket idea as with the up and down buttons on the mic ( midland ) i won't need to look at the set as much.
Click to expand...


yes yu will - coz when yu grab the mic - its easy to press one of them buttons. find yu been transmitting on 1 or 2 channels away from ehat yu thought :eek: which yu dont realise until yu think "its a bit quiet lately".


how do I know? :rolleyes:
 
The Mad Hat Man said:
yes yu will - coz when yu grab the mic - its easy to press one of them buttons. find yu been transmitting on 1 or 2 channels away from ehat yu thought :eek: which yu dont realise until yu think "its a bit quiet lately".


how do I know? :rolleyes:
Click to expand...
Did have that problem, cured that buy putting some mirror film just between the radio and the headlining and can see the screen ok everything is backwards but as my rig only has 40 channs not to bad:)
 
You must log in or register to reply here.

Similar threads

TD5 Pilot
CB radio install
Replies
4
Views
567
TD5 Pilot
TD5 Pilot
J
Disco 2 TD5 Landmark 2004 - hi-line system - aftermarket stereo rubbish radio reception
Replies
7
Views
850
Jayridium
J
O
cb radio handset sets off wipers
Replies
14
Views
705
TheQ
T
Montyjohn
P38A Should I put a modern touch screen radio in my car?
2
Replies
37
Views
1K
kermit_rr
kermit_rr
I
Disco 2 Citizen Band Radio engine noise
2
Replies
32
Views
2K
Stanleysteamer
Stanleysteamer
Back
Top