pussa13
Active Member
- Posts
- 160
- Location
- Leyburn North Yorkshire
Hi all can anyone give me some pointers on fitting a rear crankshaft oil seal please, I've had one attempt and don't want to %&*$ it up again !
Thanks.
Thanks.
oil seal
- Thread starter pussa13
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
NickT
New Member
- Posts
- 95
- Location
- Derbyshire
What engine?
pussa13
Active Member
- Posts
- 160
- Location
- Leyburn North Yorkshire
Sorry, It's in a 200tdi.
NickT
New Member
- Posts
- 95
- Location
- Derbyshire
Put a piece of tape or similar around the crankshaft to ease the seal over and use plenty
of oil on all faces. Keeping it square as it goes in is paramount, so if you haven't a suitable
follower, just use a CLEAN faced hammer to tap it in ensuring you work around it evenly
and obviously don't strike the crankshaft.
Are you changing the crucifix seals at the same time?
of oil on all faces. Keeping it square as it goes in is paramount, so if you haven't a suitable
follower, just use a CLEAN faced hammer to tap it in ensuring you work around it evenly
and obviously don't strike the crankshaft.
Are you changing the crucifix seals at the same time?
pussa13
Active Member
- Posts
- 160
- Location
- Leyburn North Yorkshire
Crucifix seals ... ?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its better if flywheel housing is removed ,and use a suitable dolly to knock new seal in square ,check crank boss and clean up if grooved move seal so it sits slightly further back and so not in groove ,if you get genuine seal it should come with guide to help fit over crank boss err2532g google it and youll see ,you will also need new gasket for flywheel housing err1440
