Wheel nut Studs

pornstarmax · Feb 10, 2011

Help me nuts are too long!!!!!!

Wheel nut pins on my front axle are about 10mm shorter than rear's (front axle is Mil unit) with Large drums.

Anyone changed to longer type and tips on how to do it?

May seen a stupid question, but I've not had em to bits yet...

MX

jamesmartin · Feb 10, 2011

studs can be pressed out

oxides · Feb 10, 2011

The parts book shows the same studs for all the axles. They're easy to replace 'cos they're just held into the hubs with splines. Knock the old ones out, tap the new ones in, probably easiest done with the hubs out.

pornstarmax · Feb 10, 2011

Nice one lads,

I'm guessing tap out from wheel side to Axle?

MX

protactor · Feb 10, 2011

Yes, cos other wise you would pull 'em out when doing em up!

pornstarmax · Feb 11, 2011

protactor said:
Yes, cos other wise you would pull 'em out when doing em up!

Yeah figured....

Wheel nut Studs

pornstarmax

Active Member

jamesmartin

Well-Known Member

oxides

Well-Known Member

pornstarmax

Active Member

protactor

New Member

pornstarmax

Active Member

Similar threads