Series 2 Suitable clutch after 200tdi conversion

May I have some advice please.
Seven years ago my 1962 Series 2a 2286cc petrol was converted to an ex Discovery 200tdi using the original 2a gearbox. The diffs were changed to 3.54 to 1 from a scrapped Range Rover last year and now clutch slip has developed quickly on a clutch which has covered only 6k miles since the tdi conversion.

It's a 9 .5 inch clutch bought then from one of the "big" reproduction parts concerns, you know who I mean.
Can I have your advice on which make of clutch I should buy now. The 200tdi engine has done for the original I have no doubt.
I don't want to buy a heavy duty clutch because most result in a heavy clutch pedal operation.

Thank you.

Glencoyne recomends 9.5 clutch plate and discovery pressure plate.
AP brand have a good reputation as have Borg and beck.
Has the plate become contaminated with oil or friction material worn away?

Some info here:
https://www.steveparkers.com/conver...gine-conversion-kits-into-series-land-rovers/

Just as a side note. Did you modify the bell housing/timing cover? If not, then the engine isn't directly bolted to the gearbox, which can cause movement and failed rear seals. Which could leak onto the clutch.

Have a read of the link I posted.

borg and beck sprung to my mind, recall hearing a lot of good things about them

I thought AP and Borg and Beck were the same company? Something to do with trade agreements/import duties?

Thank you all for your replies.
When the Tdi engine was fitted a Series 3 bellhousing was used as it made the conversion easier by using a S3 slave cylinder as well.
The 2a went in for it's MOT yesterday and I was able to have a good look for any dampness or signs of fluid leak - there were none so I assume the friction material is worn.
A Discovery clutch plate will be on the "to buy" list.

You have all been very helpful, thank you.

I thought the discovery clutch plate had the wrong number of splines for a series gearbox input shaft?

I suspect confusion arises because people simply say 'plate' and don't always specify if they are meaning the pressure plate or the friction plate.

However if anyone had clicked the link I provided earlier, it is rather explicit.


However my hunch is, if this wasn't done, then this is maybe the root cause:


There was a thread on here a couple of days ago were a member had posted pictures of doing this.