110 csw rear tub - I need to get the z section out that joins the 2nd row foot wells to the higher level of the rear tub.
This bit -
I've taken out the rivets and spot welds, but there are fasteners through, into the floor strengtheners, that *look* (from below) like they may be threaded?
These ones -
I can't tell for sure what they are really. This is the top side of them -
Now, obviously, I can take an axe to them, and they're going to move, but if I want to remove them (and, more importantly, replace somthing similar when the z section is replaced) what's my best plan?
Are they threaded? I can't find my left hand drill bits, but, if I could, I'd have tried drilling with them.
Like I say, getting them out isn't the hard bit. It's putting it back again that is what I'm thinking of.
Thank you.
This bit -
I've taken out the rivets and spot welds, but there are fasteners through, into the floor strengtheners, that *look* (from below) like they may be threaded?
These ones -
I can't tell for sure what they are really. This is the top side of them -
Now, obviously, I can take an axe to them, and they're going to move, but if I want to remove them (and, more importantly, replace somthing similar when the z section is replaced) what's my best plan?
Are they threaded? I can't find my left hand drill bits, but, if I could, I'd have tried drilling with them.
Like I say, getting them out isn't the hard bit. It's putting it back again that is what I'm thinking of.
Thank you.