rear electric window??

rear window only goes down a short distance as normal when open/close rear door
but window does not opperate at interior switch and from holding open button on fob???

fuse f31 ok and swapped reay 5 in internal fuse box???

any ideas??????????

i assume that the same motor that drops window is the same as what drops on open/close of rear door???
so fuse ok
relay ok
did susspect internal switch? but still dont opp on fob?
cant even hear a relay clicking
any help much appreciated

no auto electricians on then??

Check fuse f14 (10 amp) and inhibitor switch as well.

The tailgate window motor is controlled by the multifunction control module so would be worth getting it scanned to see if commands are being seen by the module.

The fact that the window moves when you open the door means the module is seeing a signal from the door switch and commanding motor to move the window. So motor will be ok and module is likely to be ok.

fuse f14 is internal light?

Try dissconecting yer battery [make sure you have your radio code ] give it 20 secs of dissconection and on reconection window should drive down, with all doors shut drive it fully up using man up switch till fully home, then open taildoor with the silly drop down system ,do this three times , then try man switch down and up

is the battery in your fob OK does the car beep at you when you open the door if so you need a new battery

no battery fob ok, but still wimdow doesnt work from internal switch anyhow

ming can i ask where you have had this idea of disconecting battery from? have you seen this problem before?????

try holding the up part of the switch if nothing then try the down part of it.. Mine would go down whilst pressing the up part & up whilst pressing the down part.. strange i know but it might be a simple calibration problem. doing what ming says will/should re-calibrate it..

failing that,

I'd take the rear door cover off m8 & feel inside the 2 steel runners cause this sounds like you could have either a cable snapped or frayed strands of cable stopping it from working correctly.. This is what happened to me & i ended up replacing the whole regulator then i disconnected the battery for 5 mins, after re-connecting it i pressed the down switch holding it in until i got 3 bleeps then raised the window fully & it's worked fine ever since for me..

hope this helps..