P38 Rear trailing Arm bushes?

Ok having done the P38 hockey stick bushes on the front and using the special tool to achieve this i want to do the rear bushes. The bushes appear to be the plastic outer same as the front so i assume they have to have a compression tool aswell but i can find no reference to a tool part no or if one is needed.
I will not fit poly's only oe bushes so does anyone know if there is a special tool for the rear trailing arm bushes chassis end and axle end and also if there is a special tool for the panhard rod bushes?
thanks

Special tool LRT-64-001 for radius arm bushes. No tool called up for Panhard rod bushes improvisation needed. I just make tools in the lathe as needed.

thanks wammers

@wammers is there a special tool for the small bushes at the axle end did you get that info from Rave?

Spoonofinsanity said:

@wammers is there a special tool for the small bushes at the axle end did you get that info from Rave?

Click to expand...

Anything other than the forward removable bushes are part of the trailing arm. Damage the axle end and it's big money.