Doolinjames
Member
- Posts
- 83
- Location
- denny
Can someone give me instructions how to disconnect LPG loom and reconnect to petrol
P38 4.0 lit 1995 LPG take out ECU and electrics
- Thread starter Doolinjames
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 31,486
- Location
- North Shropshire
It's easiest just to leave it there and not use it
If you want to remove the loom, it depends how old it is. If it's old enough to be piggy back then just rip it out. Newer kit is inline so you'll need to cut it out of the injector loom and join it back up
If you want to remove the loom, it depends how old it is. If it's old enough to be piggy back then just rip it out. Newer kit is inline so you'll need to cut it out of the injector loom and join it back up
Doolinjames
Member
- Posts
- 83
- Location
- denny
It's a leanardo system single point.the looms from the ECU is the only thing left can I just cut the wires or will I need to reconnect anything.thanks
- Posts
- 3,313
- Location
- Near Heathrow.
As Kermit said, you need to check if it's wired inline to the P38 stuff, or piggy backed. Do not cut wires until you are sure.
Maybe an LPG specialist would know ? There's a few in Edinburgh & one in Stirling. Just give them a call, or investigate the wiring.
Maybe an LPG specialist would know ? There's a few in Edinburgh & one in Stirling. Just give them a call, or investigate the wiring.
mystery
Well-Known Member
- Posts
- 1,469
- Location
- torquay Devon
what model of Leanardo unit this may help
Doolinjames
Member
- Posts
- 83
- Location
- denny
Thanks for that.i just want to disconnect the system from the injectors so I can run it on petrol only.what wires do I cut and what do I reconnect. That's it
What wires
- Posts
- 31,486
- Location
- North Shropshire
If the switch is set to petrol then it will never run on LPG until you switch it back.
If you pull the fuse then the switch is dead and it will only run on petrol
If you pull the fuse then the switch is dead and it will only run on petrol
Doolinjames
Member
- Posts
- 83
- Location
- denny
I just need to disconnect the LPG loom from the injectors I am going to put a new system in place everything else is disconnected.thanks
As was asked, What model? before wires can be identified.
So get the new system and work you way through it I am sure you will find wires to take out for the old system on the journey that have been conveniently cut already.
In the manual above, (i didnt study it all) but did notice that the lambda sensor wire seems to be broken and connected, but then a new system would probably do the same.
J
