Disco 3 (LR3) More woes

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

13er

Member
Posts
54
Location
Ireland
Hi all , well I replaced rear drivers driveshaft but there's still another clank which I've tracked to the rear prop shaft so that's going to be replaced also , my main concern though is I think I've got the camber a bit off , any old fashioned tips to make sure I'm close enough ? Many thanks
 

Attachments

  • 20211023_145255.jpg
    20211023_145255.jpg
    490.7 KB · Views: 116
Can you not see the rust witness marks from where the bolt/bush was oriignally fitted?
I always measure centre of bolt to chassis or some other big lump, then reift to the same place.
 
Yep I have washer near enough to original position , marks were vague , I'd say she's close, but kindof stood looking at it after , also those 4 bolts for the plate covering the epb are a $#$#$%^ , not to mention the big plate stopping me reaching them , and the person who rounded them off , thanks
 
Just a word for anybody taking on the epb , do not expect it to run like a 10 min you tube video it's a total nightmare , I seem to have a bigger metal plate under spare blocking access even further, access and visibility is the real problem, I think for all the hardship with reaching and seeing it properly if I could re run id have pulled the box out
 
Back
Top