Height sensor guards

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Spridget

Spridget

Member
Posts
37
Location
Morpeth
The front height sensor covers / guards on my P38 have just about disintegrated. in fact the last time I took the sensors off I just left the guards off to be fabricated or bought at a later date. The road to hell was paved with good intentions and of course I never got round to it. Are they necessary if we're not intending to do heavy off roading?
Opinions welcome.
 
They are made of a fibros heatproof material (if I remember)
They do become all fluffy around the edges;).
I do know they come awfully close to the exhaust on a V8 both sides. If you have been running like it for a while then I guess no issue;).
Think most would say no issue without, I have both mine so couldn't really say:).

J
 
Datatek said:
Certainly needed as a heat shield on the exhaust side of the diesel.
Click to expand...
.
Great minds.............I splashed out on a new bracket and heat shield for the off side. I suppose the greatest danger of heat damage would be when stuck in slow moving traffic. Might try and patch the other side up but I don't think it does much on the diesel.
 
Spridget said:
.
Great minds.............I splashed out on a new bracket and heat shield for the off side. I suppose the greatest danger of heat damage would be when stuck in slow moving traffic. Might try and patch the other side up but I don't think it does much on the diesel.
Click to expand...
I re-made the N/S one with thin alloy sheet.
 
New bracket and guard for the OSF arrived yesterday, about £45 total including postage. I used them as a pattern to fabricate the same for the NSF which is much easier to get to. The brackets are the same but the cover/ guard is the handed. Didn't have a bean can handy so I made the cover out of some ally sheet that was lying around. Really pleased with it till I realised that I had made it the same as the OS one and had to bash it about to make it the opposite hand. :mad:.
 

Attachments

  • 1.jpg
    1.jpg
    25.2 KB · Views: 125
At one point there was some one selling some stainless steel ones, they looked nice but for the money i would make my own ones up.
 
You must log in or register to reply here.

Similar threads

Blob
L322 Adaptive Dynamics Height Sensor issue (but it works...)
Replies
2
Views
678
Graculus
Graculus
S
Height suspension / sensor issue - can't calibrate
Replies
3
Views
944
Graculus
Graculus
peaky1979
Rear height sensor
2
Replies
22
Views
1K
backinblack
backinblack
J
P38 broken/snapped height sensor arm (rear)
Replies
4
Views
687
JT_spark
J
stuu
P38A Brands advice/suggestions
Replies
4
Views
550
stuu
stuu
Back
Top