Lyn
Member
- Posts
- 19
- Location
- Swansea Valley
I am about to fit a Safari snorkel, do I need to use sensor sensitive silicon?
If so where do I get it.
If so where do I get it.
Fitting a Safari snorkel
- Thread starter Lyn
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
matthew2riches
New Member
- Posts
- 3,025
- Location
- Suffolk
Most people will use tigar seal or stikaflex. You can plastic weld them if you have the proper gear.
Freediscoranger
Active Member
- Posts
- 744
- Location
- Cirencester/ west shropshire
I was just going to use bathroom sealant. But lots of it. Fitting mine tomorrow
gizgrey
New Member
- Posts
- 393
- Location
- stirling scotland
used bathroom sealant on mine,had no probs.
GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
****e product and not really suitable with the type of plastic the snorkel is made of as the sealant won't adhere to either the snorkel or the bodywork etc. I would suggest seam sealer or Sikaflex as mentioned above.
Then again you could gamble your engine if you want on a £3.99 B&Q special
Don't mean to be disrespectful - I made a similar mistake some time ago and ended up replacing what I had done with proper seams sealant.
