Fault codes help

Sup guys need to decript these codes please.
P0606
P0306
P0500
P1471
P1472
P1605
P1562

Found a forum with code list here for the range rover those it also apply for the freelander?

Thank you

If you put the description by the code (saves us looking) we'll give you idea's on the possible fix.

P0306- cylinder 6 misfire
P0500- vehicle speed sensor A
P0606- ecm/pcm processor fault
P1471- short circuit to battery
P1472- electrodrive fan operation failure passanger side short circuit to ground
P1562- battery supply check
P1605- keep alive memory test failure

Changed cylinder 6 spark plug. engine service light still on. Can it be a coil thing now?

try deleting the codes and see which ones come back

there may be old and no longer valid ones in there

thizzlemania91 said:

Changed cylinder 6 spark plug. engine service light still on. Can it be a coil thing now?

Click to expand...

The cheap way to test a coil is to swap them to see if the problem moves. Cylinder 6 is a .... to get at though.

Are you able to perform that test?

thizzlemania91 said:

P0306- cylinder 6 misfire
P0500- vehicle speed sensor A
P0606- ecm/pcm processor fault
P1471- short circuit to battery
P1472- electrodrive fan operation failure passanger side short circuit to ground
P1562- battery supply check
P1605- keep alive memory test failure

Click to expand...

I like the code from the RAVE since they have the actual mapping to the Siemens 2000 ECU used in the NAS version. more details below. Anything happen to you ECM (ECU) or wiring loom? Any changes lately? I am talking about P0606 here.

FREELANDER 2001 TO 2004 MY
ONWARDS
WORKSHOP MANUAL - SYSTEM
DESCRIPTION AND OPERATION

Publication Part No. LRL0351 NAS - 5th Edition

Page "18-4-32 DESCRIPTION AND OPERATION" (page 69 in my pdf)

P0306- Cylinder 6 Misfire detected
P0500- Vehicle speed signal Signal implausible
P0606- ECM Processor fault
P1471- VIS balance valve motor Valve always closed
P1472- VIS power/ butterfly valves motor Valves always open

Those below are from the JATCO transmission it seems

Page "DESCRIPTION AND OPERATION 44-37" (page 154 in my pdf)

P1562 - Power supply voltage 10 – 16V engine idling Out of range
– Check wiring and connections and battery condition

P1605 All EAT ECU EEPROM EEPROM updated by EAT ECU following ignition off and before main relay opens Error flag set
– Clear flag. Power was disconnected from EAT ECU before main relay opened

The battery issue was due to a loose nut on the batter wire deal. I can get around swapping coils to check if thats the issue. I know ill need a new coil for sure because the plastic piece on the bottom of the coil (5th cyclinder)
is cracked. As for the ecm i dont jnow where thats at. I can check if i know what im looking for

The key is to clear the codes, test what you can and report again.

I look forward to you future updates